|
| |
TM 9-2320-364-34-3
16-261
(4)
Remove four nuts (5), lockwashers (6) and bulkhead fittings (7) from middle frame (2). Discard
locknuts.
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean all metal surfaces with drycleaning solvent (P-D-680).
(2)
Inspect middle frame for cracked welds or damage. Replace or repair as necessary.
(3)
Inspect bushing for wear. Replace if pivot pin has worn through bushing surface and metal is showing
through.
d.
Assembly.
(1)
Install four bulkhead fittings (7),
lockwashers (6) and nuts (5) on middle
frame (2).
|
