|
| |
TM 9-2320-364-34-3
16-308
16-47. CONTAINER HANDLING UNIT (CHU) RAIL TRANSPORT ISO CORNER
LOCKS REPAIR.
This task covers:
a. Removal
c. Cleaning/Inspection
e. Installation
b. Disassembly
d. Assembly
f. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Brush, Wire, Scratch (Item 23, Appendix F)
Compressor Unit, Air (Item 35, Appendix F)
Drill Set, Twist (Item 48, Appendix F)
Drill, Electric, Portable (Item 49, Appendix F)
Gloves, Chemical Oil Protective
(Item 81, Appendix F)
Goggles, Industrial (Item 83, Appendix F)
Gun, Air Blow (Item 86, Appendix F)
Respirator, Air Filter (Item 195, Appendix F)
Sander, Portable, Disk Electric
(Item 198, Appendix F)
Welder, Arc (Item 251, Appendix F)
References
TC 9-237
Materials/Parts
Grease, General Purpose (Item 22, Appendix B)
a.
Removal.
NOTE
There are two rail transport ISO
corner locks. Both are removed
the same way. Right side is
shown.
(1)
Lift pin (1) to unlock lock handle (2).
(2)
Loosen handnut (3), rotate handle (2) 90
degrees and remove ISO corner lock (4)
from stow weldment (5).
1
2
3
4
5
|
