|
| |
TM 9-2320-364-34-3
17-15
e.
Installation.
NOTE
Install adapters, elbows and tees
as noted prior to removal.
(1)
Position four screws (69) in pump mount
bracket (70) and position pump mount
bracket on main hydraulic pump (1).
(2)
Install four screws (104), pump mount
bracket (70) and four locknuts (103) on
main hydraulic pump (1).
(3)
Install two screws (100), lockwashers (101),
pump mount bracket (70) and spacers (102)
in main hydraulic pump (1).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(4)
Apply sealing compound on threads of
hydraulic pump shaft (99).
(5)
Install key (98), end yoke (4), washer (97)
and nut (96) on hydraulic pump shaft (99).
Tighten nut 138 lb-ft (187 N.m).
(6)
Apply hydraulic oil to preformed
packing (95).
(7)
Position preformed packing (95),
manifold (93) and split flange (28) on main
hydraulic pump (1) with two
lockwashers (94) and screws (27).
(8)
Apply hydraulic oil to preformed
packings (92).
(9)
Install two preformed packings (92) and
adapters (36) and (25) in manifold (93).
|
