|
| |
TM 9-2320-364-34-3
17-24
17-2. MAIN HYDRAULIC PUMP REPAIR (CONT).
Universal joint end caps may fall
off upon performing Step (69).
Use caution when installing
failure to comply may result in
damage to equipment.
NOTE
If tape was installed around end
caps, remove tape prior to
Step (69).
(69)
Position driveshaft (5) on end yoke (4) of
main hydraulic pump (1).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(70)
Apply sealing compound to threads of four screws (2).
(71)
Install driveshaft (5) on end yoke (4) with two straps (3) and four screws (2). Tighten screws to 25 to 30
lb-ft (34 to 41 N.m).
f.
Follow-On Maintenance:
Fill steering reservoir, (TM 9 2320-364-20).
Install Electrical Control Box (ECB), (TM 9-2320-364-20).
Fill hydraulic reservoir, (TM 9-2320-364-20).
Start engine and run for 3 minutes, (TM 9-2320-364-10).
Shut OFF engine, (TM 9-2320-364-10).
Check for oil leaks, (TM 9-2320-364-10).
Install cab engine access panel, (TM 9-2320-364-20).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
