|
| |
TM 9-2320-364-34-3
17-54
17-10. LOAD HANDLING SYSTEM (LHS) DIRECTIONAL CONTROL VALVE
REPLACEMENT (CONT).
(3)
Loosen two screws (7) and connectors (8) from directional control valve (9).
(4)
Position drain pan under directional control valve (9).
(5)
Remove four screws (10), directional control valve (9) and five preformed packings (11) from hydraulic
manifold (12). Discard preformed packings.
b.
Installation.
(1)
Apply hydraulic oil to five preformed packings (11).
(2)
Install five preformed packings (11) on directional control valve (9).
(3)
Install directional control valve (9) on hydraulic manifold (12) with four screws (10).
(4)
Install two connectors (8) with screws (7).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(5)
Apply sealing compound to heads of screws (7).
|
