|
| |
TM 9-2320-364-34-3
18-14
18-2. ENGINE ARCTIC KIT INSTALLATION (CONT).
(69)
Remove plug (79) from engine block (80).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(70)
Apply sealing compound to threads of reducer (7).
(71)
Install reducer (7) on engine block (80).
(72)
Apply sealing compound to threads of elbow (9).
(73)
Install elbow (9) to reducer (7).
(74)
Install valve (8) to elbow (9).
(75)
Apply sealing compound to threads of adapter (81).
(76)
Install adapter (81) to valve (8).
(77)
Install clamp (10) and hose (50) on
adapter (81). Tighten clamp to 40 lb-in
(4.5 N.m).
(78)
Remove eight screws (36) and heater
control access panel (82) from heater
compartment (83). Discard screws.
(79)
Remove 15 screws (36) and ECB access
panels (84) and (85) from ECB (86).
(80)
Remove four screws (36) and tilt heater
control panel (87).
|
