|
| |
TM 9-2320-364-34-3
18-34
18-3. ALTERNATOR KIT INSTALLATION (200 AMP) (CONT).
(53)
Install wire harnesses from polarity
protection control (not shown) on bracket
(93) with cushion clip (94), screw (95) and
locknut (96).
(54)
Position STE/ICE-R wire harness (97) in
truck.
NOTE
Wire 1860 is part of the
STE/ICE-R wire harness and
wire 1274 is part of the 200 AMP
polarity wire harness.
(55)
Remove nut (98), lockwasher (99) and
washer (100) from 12 volt terminal (101)
of alternator (12).
(56)
Install wire 1860 (102), wire 1274 (103),
washer (100), lockwasher (99) and nut (98)
on 12 volt terminal (101).
(57)
Tighten nut (98) to 15 lb-ft (20 Nm).
NOTE
Wire 1820/1953 are part of
STE/ICE-R wire harness and
wire 1281A is part of 200 AMP
polarity wire harness.
(58)
Remove nut (104), lockwasher (105),
washer (106), washer(s) if present (107),
and fuse link (108) with insulator washer
(109) from 24 volt terminal (110) of
alternator (12).
(59)
Install wire 1820/1953 (111), wire 1281A
(112), fuse link (108) with insulator washer
(109), washer(s) (if removed) (107),
washer (106), lockwasher (105) and nut
(104) on 24 volt terminal (110).
(60)
Tighten nut (104) to 15 lb-ft (20 Nm).
99
96
93
95
103
100
98
106
105
112
104
109
107
108
111
107
102
101
12
110
97
|
