|
| |
TM 9-2320-364-34-3
18-160
18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
NOTE
Shims are 1/16 in. (1.59 mm)
thick. Add one shim per every
1/16 in. (1.59 mm) gap.
(92)
Measure gap at center split and determine
number of shims (131) required.
(93)
Position shim(s) if required (131) in center
split and install remaining four screws
(129) and locknuts (130).
(94)
With the aid of an assistant, position five
screws (132) and locknuts (127) on right
rear roller bracket (125), frame (27) and
rear crossmember (115).
NOTE
Perform Step (95) for right side
only.
(95)
Install screw (119), two washers (118) and
locknut (117). Tighten to 175 lb-ft (237
N.m).
(96)
Repeat Step (94) for left side of truck.
(97)
Tighten six locknuts (130) on screws (129).
(98)
Tighten ten locknuts (127) on screws (132).
(99)
Remove lifting device from left rear roller
bracket (128).
NOTE
Screws and locknuts are used
in Step (299).
Spacers are used in Step
(102).
(100)
Remove two screws (133), locknuts (134),
spacer (135) and strap (124) from right rear
roller bracket (125). Retain hardware.
(101)
Repeat Steps (98) and (100) for left side of
truck.
27
125
127
129
115
131
119
130
131
133
134
124
117
132
135
128
124
125
118
118
|
