|
| |
TM 9-2320-364-34-3
18-170
18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
(142)
Position wire rope (173) through end loop
of spring (177).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
(143)
Apply sealing compound (loctite 242) to
threads of screw (181).
(144)
Position screw (181), washer (182) and end
of wire (173) on right rear roller bracket
(125).
NOTE
Wire must be pulled tight against
roller bracket when installed.
(145)
Wrap wire (173) around screw (181) and
under washer (182) and tighten screw (181)
and (171) on right rear roller bracket (125).
NOTE
Preformed packings, seals,
thrust washers, spacers and
retaining rings can be found in
boxes B and C, pack no. 7, 8,
11, 13 and 39 of CHU kit crate.
Sealing compound is applied to
metallic side of thrust washer.
(146)
Apply sealing compound (loctite 680)
supplied in kit to thrust washer (183).
(147)
Apply adhesive (loctite 409) supplied in kit
to 6 points in recessed groove for
preformed packing (184).
NOTE
Thrust washer is properly installed
with metallic side to arm.
(148)
Install seal (185), preformed packings
(184) and thrust washer (183) on arm
assembly (158).
158
184
183
185
125
177
173
182
181
171
|
