|
| |
TM 9-2320-364-34-3
18-213
NOTE
Ensure that when slider assembly
is fully stowed, handle of arm
assembly contacts the long strut.
(67)
Push down handle (197) and stow slider
assembly (186) in stowed position and
ensure handle of arm assembly (164)
contacts long strut (180).
(68)
Check wire rope (173) is tight.
(69)
Measure distance between short strut (168)
and mode switch bracket (361).
NOTE
If gap between short strut
and mode switch bracket is
not 7/16 in. 1/16 in. (11.11
mm 1.59 mm), perform
Step (70).
If gap between short strut
and mode switch bracket is
7/16 in. 1/16 in. (11.11 mm
1.59 mm), go to Step (71).
(70)
Position mode switch (272) to dimension
shown.
(71)
Tighten two screws (273) and locknuts
(274) on mode switch (272) and rear
roller bracket (128).
(72)
Deploy left arm assembly (TM
9-2320-364-10).
197
361
168
273
274
128
272
186
7/16 IN. 1/16 IN.
(11.11 MM 1.59 MM)
180
164
173
|
