|
| |
TM 9-2320-364-34-3
18-230
18-14. CONVERT DDEC II ENGINE ASSEMBLY TO DDEC III ENGINE ASSEMBLY
(CONT).
Use caution while removing
connectors from ECM. The
ECM has plastic retainers that
may break if connectors are not
properly removed.
NOTE
Connectors are removed by
gently prying up on locking tab
with connector tool and pulling
connector out.
(7)
Using connector tool, remove three wiring
harness connectors (17) from ECM (13).
(8)
Loosen two screws (18) and remove wiring
harness connectors (19) from ECM (13).
|
