|
| |
TM 9-2320-364-34-3
18-238
18-14. CONVERT DDEC II ENGINE ASSEMBLY TO DDEC III ENGINE ASSEMBLY
(CONT).
(42)
Remove wire 1032 (98) from engine oil switch (99).
(43)
Remove nut (100), lockwasher (101), and wire 1113 (102) from engine oil sending unit stud (103).
Discard lockwasher.
(44)
Remove two screws (104) and wires 1871 (105) and 1517 (106) from engine oil switch (99).
(45)
Remove screw (107), lockwasher (108), washer (109), wire 1435 (110), and shield wires (111) and (112)
from engine (42). Discard lockwasher.
(46)
Remove engine wire harness (47) from engine (42).
NOTE
DDEC II battery power wire harness has a 4-pin MC62 connector on one end and a straight 6-pin
MC17 connector from ECM on remaining end.
(47)
Disconnect MC62 connector (113).
(48)
Remove DDEC II battery power wire harness (114) from engine (42).
|
