|
| |
TM 9-2320-364-34-3
18-244
18-14. CONVERT DDEC II ENGINE ASSEMBLY TO DDEC III ENGINE ASSEMBLY
(CONT).
NOTE
Wire terminal retaining
screws are designed to be
loosened, not removed.
All eight injector wire
harness terminal retaining
screws are loosened the
same way.
Right side and left side
injector wire harnesses are
removed the same way.
Right side shown.
(76)
Loosen wire terminal retaining screws
(153) on fuel injectors (154).
(77)
Remove two screws (155), washers (156),
flange with gasket (157), and wire harness
(158) from cylinder head (159). Discard
gasket.
NOTE
One screw and washer was
removed in Step (29).
(78)
Perform Steps (76) and (77) for left side
harness.
(79)
Remove nut (160) and lockwasher (161)
from left side camshaft (162). Discard
lockwasher.
(80)
Using puller and adapter, remove camshaft
from balance pulley (163) from left
camshaft (162).
NOTE
Perform Step (81) if key or
spacer are damaged.
(81)
Remove key (164) and spacer (165) from
end of left camshaft (162).
|
