|
| |
TM 9-2320-364-34-3
18-246
18-14. CONVERT DDEC II ENGINE ASSEMBLY TO DDEC III ENGINE ASSEMBLY
(CONT).
NOTE
Pry bar positioned in hydraulic
pump driveshaft yoke on
crankshaft pulley will prevent
camshaft pulley from turning.
(86)
Install lockwasher (161) and nut (160) on
left camshaft (162). Tighten to 300 to 325
lb-ft (407 to 441 N.m).
NOTE
Right side and left side
injector harness are installed
the same way. Right side
shown.
Right side harness has black
connector, left side has gray
connector. Left side harness
is longer.
(87)
Install fuel injector wire harness (169) and
flange with gasket (157) on cylinder head
(159) with two washers (156) and screws
(155).
(88)
Connect wire terminals to fuel inlet block
on fuel injector (154) and tighten retaining
screws (153).
NOTE
Only install one screw and
washer in fuel injector harness
towards front of engine.
Remaining screw and washer will
be installed in Step (150).
(89)
Perform Steps (87) and (88) for left side
harness.
|
