|
| |
TM 9-2320-364-34-4
28-52
28-9. SWING DRIVE GEAR REDUCER REPAIR (CONT).
(3)
Position shaft (54) in press.
(4)
(Pack bearing (58) with grease and press
bearing (58) on shaft (54).
(5)
Remove shaft (54) from press.
(6)
Install shaft (54) in hub (52).
(7)
Pack bearing (59) with grease and install
bearing (59) on shaft (54).
(8)
Install lockwasher (53) and nut (55) on
shaft (54).
(9)
Tighten nut (55) until shaft (54) starts to
turn.
(10)
Position shaft (54) in soft jaw vise.
(11)
Hold shaft (54) and tighten nut (55) until
one tine on lockwasher (53) aligns with slot
in nut.
(12)
Bend tine of lockwasher (53) up in slot of
nut (55).
(13)
Remove shaft (54) from vise.
|
