|
| |
TM 9-2320-364-34-4
28-77
Use extreme care when installing
brake housing over piston or
damage to preformed packings
and backup rings may result.
NOTE
Ensure brake housing is
aligned with dowel pins.
Ensure matchmark on brake
housing and front motor
support are aligned.
(13)
Install brake housing (9) over piston (6).
Tap lightly with soft hammer until firmly
seated.
(14)
Position six lockwashers (11) and six
screws (10) in brake housing (9).
(15)
Tighten six screws (10) in brake housing
(9) in sequence shown to 50 lb-ft (68 N.m).
(16)
Move shifter arm (12) to free-spool
position and ensure ring gear (13) turns
freely.
NOTE
If ring gear does not turn freely,
perform Steps (17) through (18).
If ring gear does turn freely, go to
Follow-On Maintenance.
(17)
Loosen six screws (10) and turn
brake housing (9) slightly.
(18)
Tighten six screws (10) in sequence shown
to 50 lb-ft (68 N.m).
f.
Follow-On Maintenance.
Install hydraulic motor, (Para 28-12).
END OF TASK
|
