|
| |
TM 9-2320-364-34-4
28-87
d.
Assembly.
(1)
Position motor end hub (1) in press.
(2)
Apply hydraulic oil to bearing (2).
NOTE
Ensure groove in bearing faces
upward during installation.
(3)
Press bearing (2) in motor end hub (1).
(4)
Remove motor end hub (1) from press.
(5)
Apply hydraulic oil to preformed
packing (3).
(6)
Install preformed packing (3) in motor end
hub (1).
e.
Installation.
NOTE
Ensure spiral pins, of motor end
hub, are aligned with alignment
holes in ring gear installation.
(1)
Install motor end hub (1) on ring gear (4)
until fully seated.
(2)
Position 12 lockwashers (5) and screws (6)
in motor end hub (1).
(3)
Tighten 12 screws (6) in motor end hub (1)
70 to 95 lb-ft (95 to 129 N.m) in sequence
shown.
(4)
Apply hydraulic oil to seal (7).
NOTE
Seal is installed with rubber lip of
seal facing upward.
(5)
Install seal (7) in motor end hub (1).
f.
Follow-On Maintenance:
Install Self-Recovery Winch motor end
support, (Para 28-15).
END OF TASK
|
