|
| |
TM 9-2320-364-34-4
20-56
This task covers:
a. Removal
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Air box drains removed, (Para 20-18)
Tools and Special Tools
Tool Kit General Mechanic’s
(Item 240, Appendix F)
Lifting Tee (2) (Appendix C)
Wooden Block (2) (Appendix C)
20-19. CYLINDER HEAD REMOVAL.
a.
Removal.
NOTE
Both cylinder heads are removed
the same way. Right side shown.
(1)
Loosen two clamps (1) on breather
tubes (2) and (3).
(2)
Remove two screws (4), washers (5),
breather tube (2), hose (6), clamps (1) and
gasket (7) from cylinder head (8). Discard
gasket.
(3)
Remove two screws (9) and washers (10)
from breather tube (11).
(4)
Loosen two clamps (12) on breather
tubes (3) and (11).
(5)
Remove breather tube (11), gasket (13),
hose (14) and clamps (12) from breather
tube (3). Discard gasket.
NOTE
Perform Steps (6) and (7) only if
breather tube is damaged.
(6)
Measure and record height of breather
tube (3) extending from engine block.
(7)
Remove breather tube (3) from engine
block (15).
|
