|
| |
TM 9-2320-364-34-4
20-57
NOTE
Leave upper right and left screws
installed at this time.
(8)
Remove eight screws (16) and washers (17)
from cylinder head (8).
(9)
Install two lifting tees on cylinder head (8).
Cylinder head with lifting tees
weighs 182 lbs (83 kg). Attach
suitable lifting device prior to
removal to prevent possible
injury to personnel.
(10)
Remove two screws (16) and washers (17)
from cylinder head (8).
(11)
Lift cylinder head (8) from engine block (15)
and position on wooden blocks.
(12)
Remove and discard seal strip gasket (18),
16 water seals (19), oil seal (20) and four
compression gaskets (21) from engine
block (15).
NOTE
Note position and location of
shims prior to removal.
(13)
Remove two support shims (22) from engine
block (15). Discard shims.
(14)
Remove two lifting tees from cylinder head (8)
(15)
Repeat Steps (8) through (14) for other
cylinder head (23).
b.
Follow-On Maintenance:
Repair cylinder head, (Para 20-49).
Remove blower drive assembly, (Para 20-20).
END OF TASK
|
