|
| |
TM 9-2320-364-34-4
20-61
This task covers:
a. Removal
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Water pump assembly removed, (Para 20-22)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Pan, Drain 4 gal (Item 144, Appendix F)
20-23. ENGINE OIL FILTER AND SPIN-ON ADAPTER HOUSING AND REMOTE
ENGINE OIL FILTER MANIFOLD REMOVAL.
a.
Removal.
(1)
Position drain pan under oil filter (1).
(2)
Remove oil filter (1) from adapter
housing (2). Discard oil filter.
(3)
Remove four screws (3) from adapter
housing (2).
(4)
Remove two screws (4), lockwashers (5),
adapter housing (2) and gasket (6) from oil
cooler adapter cover (7). Discard
lockwashers and gasket.
Use care when removing springs.
Springs are under tension and
can act as projectiles when
released and could cause injury
to personnel.
NOTE
Perform Step (5) if truck is
not equipped with remote
engine oil filter manifold.
Perform Steps (6) through
(8) if truck is equipped with
remote engine oil filter
manifold.
(5)
Remove screw (8), retainer (9), spring (10)
and bypass disk (11) from adapter
housing (2). Discard spring.
|
