|
| |
TM 9-2320-364-34-4
20-86
This task covers:
a. Removal
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Camshaft assemblies removed, (Para 20-34)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
20-35. REAR CYLINDER BLOCK PLATE REMOVAL.
a.
Removal.
(1)
Remove screw (1) and lockwasher (2) from
end plate (3). Discard lockwasher.
(2)
Remove four screws (4) from end plate (3).
(3)
Remove end plate (3) and gasket (5) from
engine block (6). Discard gasket.
Support rear end plate on flat,
even surface when removing
screw inserts to prevent warping
or bending of end plate.
NOTE
Perform Steps (4) and (5) only if
screw inserts are damaged.
(4)
Remove two screw inserts (7) from end
plate (3). Discard inserts.
(5)
Remove eight screw inserts (8) from end
plate (3). Discard inserts.
b.
Follow-On Maintenance:
Remove front cylinder block plate, (Para 20-36).
END OF TASK
|
