|
| |
TM 9-2320-364-34-4
20-87
This task covers:
a. Removal
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Rear cylinder block plate removed, (Para 20-35)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
20-36. FRONT CYLINDER BLOCK PLATE REMOVAL.
a.
(1)
Remove five screws (1) from front end plate (2).
(2)
Remove two screws (3) and lockwashers (4) from front end plate (2). Discard lockwashers.
(3)
Remove front end plate (2) and gaskets (5) and (6) from engine block (7). Discard gaskets.
Support front end plate on flat,
even surface when removing
screw inserts to prevent warping
or bending end plate.
NOTE
Perform Steps (4) and (5) only if
screw inserts are damaged.
(4)
Remove screw insert (8) from front end
plate (2). Discard inserts.
(5)
Remove two screw inserts (9) from front
end plate (2). Discard inserts.
b.
Follow-On Maintenance:
Remove crankshaft pulley, (Para 20-37).
END OF TASK
|
