|
| |
TM 9-2320-364-34-4
20-96
20-40. PISTON, CONNECTING ROD AND LINER REMOVAL (CONT).
(12)
Position bearing cap (7), upper bearing
shell (10), lower bearing shell (8) and two
nuts (6) and bearing cap screws (5) on
connecting rod (9).
(13)
Perform Steps (6) through (12) to remove
seven remaining pistons (2) and connecting
rods (9).
NOTE
Crankshaft may have to be
turned to allow for clearance of
removal tool.
(14)
Using assembly remover, remove liner (3)
from engine block (4).
(15)
Remove cylinder liner insert (11) from
cylinder bore (12).
(16)
Remove and discard two cylinder liner seal
rings (13) from cylinder bore (12).
(17)
Repeat Steps (14) through (17) to remove
seven remaining cylinder liners.
b.
Follow-On Maintenance:
Repair piston and connecting rod,
(Para 20-60).
Remove engine oil pump drive gear,
(Para 20-41).
END OF TASK
|
