|
| |
TM 9-2320-364-34-4
20-128
c.
Assembly.
NOTE
All 32 exhaust valves are
installed the same way.
Repeat Steps (2) through (4)
for each valve.
(1)
Position cylinder head (1) on side on
wooden blocks.
(2)
Lubricate valve (2) with lubricating oil.
(3)
Install valve (2) in cylinder head (1).
(4)
Secure valve (2) with tape to keep from
falling out of cylinder head (1).
NOTE
Wooden blocks must be high
enough to keep exhaust valves
from touching work surface
while installing spring locks.
(5)
Position cylinder head (1) right side up on
wooden blocks.
(6)
Install valve seat (3) over valve guide (4).
NOTE
Plastic cap which comes with oil
seal may be placed over exhaust
valve to protect exhaust valve
from being scratched upon
installation of oil seal. Ensure
plastic cap is removed after
installation of oil seal.
(7)
Using valve guide seal installer, install oil
seal (5) on valve guide (4).
|
