|
| |
TM 9-2320-364-34-4
20-223
(6)
Install two T-handles (11) in plates.
(7)
Install two plates on right and left cylinder
banks of engine block (5) with 20
spacers (12), screws (13).
(8)
Tighten screws (13) to 50 lb-ft (68 N.m).
Continue tightening in sequence shown,
increments of 50 lb-ft (68 N.m), until all
screws (13) are tightened 250 to 260 lb-ft
(339 to 353 N.m).
(9)
Install gasket (14) and water inlet cover
plate on right front side of engine block (5)
with four lockwashers (15), two screws (16)
and nuts (17).
(10)
Install air adapter fitting (18) in right rear
of engine block (5).
(11)
Connect air line to fitting (18). Route air
line from above engine block (5) to prevent
antifreeze solution from draining into hose.
|
