|
| |
TM 9-2320-364-34-4
20-230
20-65. MAIN BEARING AND CRANKSHAFT INSTALLATION (CONT).
(12)
Wipe oil from bearing shells and crankshaft
main bearing journals.
(13)
Place strip of plastic gage across width of
bearing shell (12) 1/4 in. (6.35 mm) from
center.
(14)
Repeat Step (13) for four other bearing
caps.
(15)
Install five bearing caps (9) and (14).
(16)
Strike bearing caps (9) and (14) with soft-
face hammer.
(17)
Install ten screws (15).
(18)
Tighten ten screws (15) 50 lb-ft (68 N.m).
(19)
Strike bearing caps (9) and (14) with soft-
face hammer.
(20)
Tighten ten screws (15) 110 lb-ft
(149 N.m).
(21)
Tighten ten screws (15) 230 to 240 lb-ft
(312 to 325 N.m).
(22)
Remove ten screws (15) and five bearing
caps (9) and (14).
|
