|
| |
TM 9-2320-364-34-4
20-236
20-67. PISTON, CONNECTING ROD AND LINER INSTALLATION (CONT).
(6)
Inspect ring compressor for nicks and burrs.
Sand smooth with 1000 grit paper. Replace
ring compressor if any nicks or burrs cannot
be removed.
(7)
Apply lubricating oil to piston ring set (5)
and (6), piston (7) and inside of ring
compressor.
(8)
Stagger piston ring (5) gaps and install
piston (7) in ring compressor.
(9)
Coat inside of cylinder liner (8) with
lubricating oil.
(10)
With aid of assistant, hold cylinder liner (8),
flange end down, while placing ring
compressor with piston (7) on cylinder
liner (8).
(11)
Make sure number on rod bearing cap (9)
matches number on cylinder liner (8).
(12)
Align letters on rod bearing cap (9) with
letters on cylinder liner (8).
(13)
Push piston (7) into cylinder liner (8) until
piston is free from ring compressor.
Remove ring compressor.
(14)
Push piston (7) into cylinder liner (8) until
compression rings (6) pass cylinder liner
ports (10).
(15)
Remove two nuts (11), bearing cap (9) and
bearing shell (12).
(16)
Coat connecting rod bearing shells (12)
and (13) with lubricating oil.
|
