|
| |
TM 9-2320-364-34-4
20-248
20-71. FRONT CYLINDER BLOCK PLATE INSTALLATION (CONT).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(3)
Coat block plate gaskets (4) and (5) with sealing compound and install on engine block (6).
(4)
Position front block plate (1), five screws (7), two lockwashers (8) and screws (9). Tighten screws finger
tight.
(5)
Position right bank camshaft end bearing (10) in engine block (6).
(6)
Tighten five screws (7) 30 to 35 lb-ft (41 to 47 N.m).
(7)
Tighten two screws (9) 71 to 75 lb-ft (96 to 102 N.m).
(8)
Remove end bearing (10) from block plate (1).
b.
Follow-On Maintenance:
Install rear cylinder block plate, (Para 20-72).
END OF TASK
|
