| |
TM 9-2320-364-34-4
20-309
NOTE
Flat side of injector gage faces injector follower.
Some supply brake wire harness connectors may have to be removed to adjust fuel injector
timing.
(2)
Insert 1.520 in. (38.608 mm) injector gage in hole at top of fuel injector body (11).
(3)
Hold injector rocker arm push rod (12) and loosen locknut (13).
(4)
Turn push rod (12) and adjust injector rocker arm (14) so flat side of injector gage passes just over top of
injector follower (15).
(5)
Hold push rod (12) and tighten locknut (13).
(6)
Put injector gage into fuel injector body (11) and recheck clearance of injector follower (15). If
clearance is not correct repeat Steps (2) through (5).
(7)
Repeat Steps (1) through (6) for other seven fuel injectors.
d.
Follow-On Maintenance:
Install blower assembly, (Para 20-95).
END OF TASK
|