|
| |
TM 9-2320-364-34-4
20-315
Materials/Parts
Grease (Item 21, Appendix B)
Sealing Compound (Item 53, Appendix B)
Sealing Compound (Item 56, Appendix B)
Gasket (Item 104, Appendix E)
This task covers:
a. Installation
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Rocker cover installed, (Para 20-97)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Wrench, Torque (0 to 175 lb-ft [0-237 N.m])
(Item 277, Appendix F)
20-98. FUEL PUMP ASSEMBLY INSTALLATION.
a.
Installation.
(1)
Apply grease to gasket (5).
(2)
Position gasket (5) on fuel pump (3).
(3)
Align drive coupling fork (6) in fuel pump (3) with blower shaft and position fuel pump on blower
housing (7).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(4)
Coat threads of three screws (4) with sealing
compound.
(5)
Install screws (4) in fuel pump (3). Tighten
120 to 156 lb-in (14 to 18 N.m).
(6)
Coat threads of tee fitting (1) and bushing
(2) with sealing compound.
NOTE
Install tee in same position and
location as noted during removal.
(7)
Install bushing (2) in fuel pump (3).
(8)
Install tee fitting (1) in bushing (2) and fuel
pump (3).
b.
Follow-On Maintenance:
Install secondary fuel filter, head and fuel hoses, (Para 20-99).
END OF TASK
|
