|
| |
TM 9-2320-364-34-4
21-5
NOTE
Use five screws with puller tools
on rear end plate. Use 5/16-24
by 1-1/2 in. (38 mm) screws and
align with tapped holes in gears.
(15)
Install puller on left timing gear (24) with
two screws (25).
(16)
Install puller on right timing gear (17) with
three screws (25).
If puller screws are not tightened
evenly during removal of timing
gears, damage to gears may
result.
(17)
Tighten screws (26) on pullers evenly to
remove right timing gear (17) and left
timing gear (24).
(18)
Remove pullers and five screws (25) from
timing gears (17) and (24).
NOTE
Amount of shims may vary
on each shaft.
Tag and mark shims during
removal.
(19)
Remove shims (27) and spacer (28) from
each rotor shaft (29).
|
