|
| |
TM 9-2320-364-34-4
21-21
(61)
Install three spacers (45) and hub (44) with
three screws (46) on gear (24). Tighten
screws 25 to 30 lb-ft (34 to 41 N.m).
(62)
Remove cleaning cloth from blower
housing (9).
(63)
Install gasket (47) and rear end plate
cover (48) on blower housing (9).
(64)
Install nine lockwashers (49) and screws (50)
on rear end plate cover (48). Tighten screws
evenly 156 to 204 lb-in (18 to 23 N.m).
(65)
Install preformed packing (51) on by-pass
valve (52).
(66)
Install by-pass valve (52) on blower (9)
until fully seated.
(67)
Install pressure clamp (53) on bypass
valve (52).
(68)
Install two screws (54) in pressure clamp
(53). Tighten screws 23 to 26 lb-ft
(31 to 35 N.m).
(69)
Install two clamps (55) and (56) on
hose (57).
|
