|
| |
TM 9-2320-364-34-4
23-2
This task covers:
a. Installation
b. Removal
c. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Transmission removed from container,
(Para 7-11)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
Cap and Plug Set (Item 26, Appendix F)
Fixture, Holding (Item 61, Appendix F)
Pan, Drain 4 gal (Item 144, Appendix F)
Stand, Maintenance, Engine
(Item 226, Appendix F)
Wrench, Crowsfoot, 3/4 in., 3/8 in. Drive
(Item 268, Appendix F)
Wrench Set, Socket 3/8 in. Drive
(Item 273, Appendix F)
Wrench, Torque (0-175 lb-ft [0-237 N.m])
(Item 276, Appendix F)
Wrench, Torque (0-60 N.m)
(Item 277, Appendix F)
Lifting Device, Minimum Capacity 2000 lbs
(908 kg)
Screw 5/8-11 by 2-1/2 in. (4)
Locknut 5/8-11 (4)
23-2. TRANSMISSION ON STAND INSTALLATION/REMOVAL.
Materials/Parts
Cable Ties (Item 9, Appendix B)
Oil, Hydraulic (Item 34, Appendix B)
Sealing Compound (Item 53, Appendix B)
Tags, Identification (Item 72, Appendix B)
Lockwasher (4) (Item 237, Appendix E)
Packing, Preformed (4) (Item 352, Appendix E)
a.
Installation.
NOTE
Tag and mark all hoses prior
to removal.
Note location of tie straps
and remove as required.
Cap and plug all lines and
fittings after removal.
(1)
Remove hose 2279 (1), fitting (2), and
preformed packing (3) from
transmission (4). Discard preformed
packing.
(2)
Remove hose 2382 (5), elbow (6) and
preformed packing (7) from
transmission (4). Discard preformed
packing.
|
