|
| |
TM 9-2320-364-34-4
23-57
(2)
With the aid of an assistant, position torque
converter housing (1) with engine mounting
surface facing down.
(3)
Install gasket (42) on torque converter
housing (1).
(4)
Align holes and install front support
assembly (27) on torque converter
housing (1). Tap lightly with soft faced
hammer until front support assembly (27)
is fully seated.
(5)
Position three screws (41) in front support
assembly (27).
(6)
Position 14 screws (40) in front support
assembly (27).
(7)
Tighten three screws (41) in front support
assembly (27) to 36 to 43 lb-ft
(49 to 58 N.m).
(8)
Tighten 14 screws (40) in front support
assembly (27) to 36 to 43 lb-ft (49 to 58 N.m)
in sequence shown.
NOTE
Perform Step (9) only if bearing
was removed.
(9)
Coat bearing (38) with grease and, using
bearing installer and driver handle, install
bearing in ground sleeve bore (39).
|
