|
| |
TM 9-2320-364-34-4
23-70
23-13. FORWARD CLUTCH AND TURBINE SHAFT REPAIR (CONT).
NOTE
Perform Steps (21) through (30)
if replacement of PTO gear is
required.
(21)
Position forward clutch and turbine shaft
assembly (6) in press.
NOTE
If removal of PTO gear is
required, remove oil collector
ring first.
(22)
Support oil collector ring (22) on inner
circumference and press forward clutch
housing and turbine shaft assembly (6)
from oil collector ring (22).
(23)
Locate retaining ring gap at cutout nearest
gap and press retaining ring (23) into
groove in forward clutch housing (24).
(24)
Slip piece of shim stock (3/32 by 0.020 by
3 in.) between retaining ring (23) and inner
ends of splines of PTO gear (25). Repeat
operation at other side of retaining ring
gap.
(25)
Working at each opening (missing spline)
to compress retaining ring (23), insert eight
more pieces of shim stock at approximately
3 in. (76 mm) increments.
(26)
Position PTO gear removal fixture, flat side
downward, on press.
(27)
Position forward clutch and turbine shaft
assembly (6), turbine shaft (2) downward,
so PTO gear rests on tool. Center PTO
gear removal fixture directly under PTO
gear.
(28)
Position PTO gear removal tool in forward
clutch housing (24). Center PTO gear
removal fixture in forward clutch housing.
(29)
Press forward clutch housing (24) from
PTO gear (25).
(30)
Remove PTO gear (25) and retaining
ring (23) from forward clutch housing (24).
|
