|
| |
TM 9-2320-364-34-4
23-92
23-16. CENTER SUPPORT REPAIR (CONT).
a.
Removal.
(1)
Remove and discard center support anchor
screw (1) and washer (2) from transmission
housing (3).
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(2)
Remove retaining ring (4) from
transmission housing (3).
(3)
Install lifting bracket on center support (5).
Center support housing is fitted
to transmission housing with
very little clearance and may
bind if transmission housing is
cold. Heat transmission housing
with heat lamp or warm current
of air if necessary.
(4)
Lifting straight up, remove center
support (5) from transmission housing (3).
If center support begins to bind, tap center
support downward and lift again.
(5)
Position center support (5) on level work
surface.
(6)
Remove and discard thrust washer (6) from
transmission housing (3).
(7)
Remove lifting bracket from center
support (5).
|
