|
| |
TM 9-2320-364-34-4
23-94
23-16. CENTER SUPPORT REPAIR (CONT).
(7)
Turn center support (3) over.
Compressed air used for
cleaning purposes will not
exceed 30 psi (207 kPa). Use
only with effective chip guarding
and personal protective
equipment (goggles/shield,
gloves, etc). Failure to comply
may result in injury or death to
personnel.
(8)
Apply short bursts of compressed air to first
hole (9) on right to loosen third clutch
piston (10).
(9)
Remove third clutch piston (10) from center
support (3).
NOTE
Note position of lips on
preformed packings. Lips are
facing away from springs.
(10)
Remove and discard preformed
packings (11) and outer (12) from third
clutch piston (10).
(11)
Cut, remove, and discard four push-on
nuts (13) from third clutch piston (10).
(12)
Remove spring retainer plate (14) from
third clutch piston (10).
(13)
Remove 20 piston release springs (15) from
third clutch piston (10). Discard springs.
|
