|
| |
TM 9-2320-364-34-4
23-124
23-18. REAR TRANSMISSION COVER ASSEMBLY REPAIR (CONT).
Slot in speed sensor gear must be aligned with lube hole in shaft or damage to equipment could
result.
(16)
Install speedometer drive gear (16) on output shaft (13).
(17)
Position output shaft (13) in press.
(18)
Press speed sensor gear (15) on output shaft (13).
NOTE
Groove in bearing faces toward yoke end in shaft.
(19)
Press bearing (14) on output shaft (13).
(20)
Remove output shaft (13) from press.
(21)
Position rear cover (8) on side on wooden blocks.
(22)
Install output shaft (13) in rear cover (8) until bearing (14) clears retaining ring groove (26) in rear cover.
|
