|
| |
TM 9-2320-364-34-4
24-20
24-8. TRANSFER CASE ASSEMBLY REPAIR (CONT).
(23)
Remove 18 screws (32) from flange of front
housing (33).
(24)
Position two screws (32) from Step (23) in
half jackscrew holes at each end of front
housing (33).
(25)
Tighten two screws (32) from Step (23) to
break seal between front housing (33) and
rear housing (4).
(26)
Attach three lifting eyes and lifting device
rear housing (4).
Rear housing weighs 210 lbs
(95 kg). Attach suitable lifting
device before removal to prevent
possible injury to personnel.
Lift rear housing straight up
to prevent damage to upper
and lower shift rods.
As rear housing is lifted, ball
and spring retained in rear
housing for upper shift rod
may fall out. Be careful to
prevent loss of these parts.
(27)
Remove rear housing (4) from front
housing (33).
(28)
Remove and discard ball (34) and
spring (35) from rear housing (4).
(29)
Remove two screws (32) from half jackscrew
holes.
(30)
Remove three lifting eyes and lifting device
from rear housing (4).
|
