|
| |
TM 9-2320-364-34-4
20-13
This task covers:
a. Removal
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine installed on stand, (Para 20-2)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
20-3. EXHAUST MANIFOLD REMOVAL.
a.
Removal.
NOTE
Right and left exhaust manifolds
are removed the same way.
Right side shown.
(1)
Remove two clamps (1) and exhaust tube (2)
from turbocharger adapter tee (3) and
exhaust manifold (4).
(2)
Loosen five locknuts (5) and remove exhaust
manifold (4) from cylinder head (6).
NOTE
Center locknut on left side has a
bracket.
(3)
Remove five locknuts (5), three washers (7)
and two crabs (8) from cylinder head (6).
Discard locknuts.
(4)
Remove two gaskets (9) from cylinder
head (6). Discard gaskets.
NOTE
Perform Step (5) only if studs are
damaged.
(5)
Remove studs (10) from cylinder head (6).
Discard studs.
b.
Follow-On Maintenance:
Remove Electronic Control Module (ECM),
(Para 20-4).
END OF TASK
|
