|
| |
TM 9-2320-364-34-4
24-59
(4)
Remove bearing (5) from bearing race (6).
(5)
Remove spacer (7) from bearing cap (2).
(6)
Remove bearing race (6) from bearing
cap (2).
Use care when removing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(7)
Remove two retaining rings (8) from bearing
cap (2).
(8)
Remove bearing (9) and bearing race (10)
from bearing cap (2).
NOTE
Perform Step (9) only if adapter
and plug are damaged.
(9)
Remove adapters (11) and (12) and
plug (13) from bearing cap (2).
b.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc).
Failure to comply may result in injury or death to personnel.
NOTE
Bearing assembly is a matched set. Replace all components if any damage is found.
(1)
Clean all metal parts with drycleaning solvent.
(2)
Dry with compressed air.
|
