|
| |
TM 9-2320-364-34-4
24-63
(8)
Install spacer (7) on front shaft (3).
(9)
Coat outboard bearing (5) with grease.
(10)
Using press, install bearing in bearing
cap (2) until fully seated.
(11)
Ensure that front shaft (3) turns freely. If
binding occurs, using a soft faced hammer,
tap shoulder of bearing cap (2).
(12)
Coat inner lip of oil seal (1) with grease.
NOTE
Ensure lip of seal is facing inside
of bearing cap.
(13)
Install oil seal (1) in bearing cap (2).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and water.
NOTE
Perform Steps (14) and (15) only
if plug and adapters were
removed.
(14)
Apply sealing compound to pipe plug (13)
and adapters (11) and (12).
(15)
Install pipe plug (13) and adapters (11) and
(12) in bearing cap (2).
d.
Follow-On Maintenance:
Install front shaft in transfer case, (Para 24-8).
END OF TASK
|
