| |
TM 9-2320-364-34-4
25-24
25-7. AXLE NO. 1, 2 AND 5 WHEEL HUB ASSEMBLY REPAIR (CONT).
NOTE
Perform Steps (3) or (4) if
studs were removed.
Install four longer studs in
positions marked during
disassembly.
Ensure flat edge of stud
head is positioned parallel to
edge of wheel hub.
(3)
Install studs (11) in wheel hub (2).
(4)
Install studs (12) in wheel hub (2).
(5)
Coat seals (8) and (9) with grease.
(6)
Using seal driver, install guide ring (10) and
seal (9) in wheel hub (2).
(7)
Using seal driver, install seal (8) in wheel
hub (2).
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(8)
Install outside ring (7) and retaining ring (6)
in wheel hub (2).
(9)
Coat bearing races (4) and (5) with grease.
(10)
Install bearing races (4) and (5) in wheel
hub (2).
(11)
Pack bearing (3) with grease.
(12)
Install bearing (3) in wheel hub (2).
(13)
Coat oil seal (1) with grease.
(14)
Install oil seal (1) in wheel hub (2).
10
9
6
8
7
SEAL
DRIVER
SEAL
DRIVER
12
2
11
|