|
| |
TM 9-2320-364-34-4
25-61
(15)
Install oil seal (5) in axle housing (6).
(16)
Install dust cover (4) on flange assembly
NOTE
Flange assembly should be
positioned so large openings of
flange assembly align with slots
of pinion shaft. This will ease
staking of nut.
(17)
Install flange assembly (3) on pinion
shaft (2).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(18)
Coat threads of pinion shaft (2) with adhesive.
(19)
Apply adhesive to face of flange assembly (3) where adjusting nut (1) seats.
(20)
With the aid of an assistant, and using flange holder and socket, install adjusting nut (1)
on pinion shaft (2) using flange holder. Tighten adjusting nut to 680 to 796 lb-ft
(922 to 1,079 N.m).
(21)
Ensure adhesive has squeezed out around entire outside diameter of adjusting nut (1). If adhesive is not
visible around entire outside diameter of adjusting nut (1), remove and discard adjusting nut (1) and
repeat Steps (18) through (19).
(22)
Stake adjusting nut (1) in two slots of pinion shaft (2) directly 180 degrees apart.
c.
Follow-On Maintenance:
Install constant velocity joint, (Para 25-13).
END OF TASK
|
