|
| |
TM 9-2320-364-34-4
25-76
25-15. AXLE NO. 1 AND 5 DIFFERENTIAL ASSEMBLY REPAIR (CONT).
(50)
Remove one of four screws (20) from bearing caps (19).
Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(51)
Coat threads of screw (20) with sealing
compound.
(52)
Install screw (20) and tighten 123 to 137 lb-ft
(167 to 186 N.m).
(53)
Repeat Steps (47) through (49) for three
remaining screws (20).
(54)
Coat threads of screw (17) with sealing
compound.
(55)
Install nut locking plate (18) to bearing
cap (19) with screw (17). Tighten to 132 to
216 lb-in (15 to 24 N.m).
(56)
Install fork (11) with retaining pin (15) in
differential housing (16).
(57)
Stake retaining pin (15) on largest diameter
end.
(58)
Coat both ends of retaining pin (15) with
adhesive.
(59)
Install two finger forks (14) in fork (11).
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released and
could cause severe eye injury.
(60)
Install clutch gear (13) on fork (11) with
retaining ring (12).
|
