|
| |
TM 9-2320-364-34-4
25-118
25-20. AXLE NO. 3 AND 4 WHEEL HUB ASSEMBLY REPAIR (CONT).
d.
Assembly.
(1)
Pack bearing (18) with grease.
(2)
Using press, install bearing (18) on ring gear
carrier assembly (7).
NOTE
Perform Steps (3) or (4) if studs
were removed.
Install four longer studs in
positions marked during
disassembly.
Ensure flat edge of stud head is
positioned parallel to edge of
wheel hub.
(3)
Install studs (3) in wheel hub (1).
(4)
Install studs (17) in wheel hub (1).
(5)
Coat seals (14) and (15) with grease.
(6)
Using seal driver, install guide ring (16) and
seal (15) in wheel hub (1).
(7)
Using seal driver, install seal (14) in wheel
hub (1).
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released
causing injury to personnel.
(8)
Install outside ring (13) and retaining
ring (12) in wheel hub (1).
16
15
12
14
13
SEAL
DRIVER
SEAL
DRIVER
17
1
3
|
