|
| |
TM 9-2320-364-34-4
25-141
b.
Installation.
(1)
Coat oil seal (5) with grease.
(2)
Install oil seal (5) in housing (6).
(3)
Install dust cover (4) on flange assembly (3)
NOTE
Flange assembly should be
positioned so large openings of
flange assembly align with slots
of pinion shaft. This will ease
staking of nut.
(4)
Install flange assembly (3) on pinion
shaft (2).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(5)
Coat threads of pinion shaft (2) with
adhesive.
(6)
Apply adhesive to face of flange assembly
(3) where adjusting nut (1) seats.
(7)
With the aid of an assistant and using flange
holder and socket install adjusting nut (1) on
pinion shaft (2). Tighten adjusting nut to
680 to 796 lb-ft (922 to 1,079 N.m).
(8)
Ensure adhesive has squeezed out around entire outside diameter of adjusting nut (1). If adhesive is not
visible around entire outside diameter of adjusting nut (1), remove and discard adjusting nut (1) and
repeat Steps (6) and (7).
(9)
Stake adjusting nut (1) in two slots of pinion shaft (2) directly 180 degrees apart.
c.
Follow-On Maintenance:
Install axle shafts, (Para 25-25).
END OF TASK
|
