|
| |
TM 9-2320-364-34-4
20-34
This task covers:
a. Removal
b. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Turbocharger and air inlet housing removed,
(Para 20-5)
Tools and Special Tools
Tool Kit, General Mechanic’s
(Item 240, Appendix F)
20-6. ENGINE LIFTING BRACKETS REMOVAL.
a.
Removal.
(1)
Remove screws (1) and (2), lockwashers (3)
and (4) and front lifting bracket (5) from
front balance cover (6). Discard
lockwashers.
NOTE
Left and right rear lifting
brackets are removed the same
way. Right side shown.
(2)
Remove two screws (7), lockwashers (8)
and washers (9). Discard lockwashers.
NOTE
Washer in Step (3) is located on
right side only.
(3)
Remove screw (10) and lockwasher (11)
from rear lifting bracket (12). Discard
lockwasher.
NOTE
Perform Step (4) for left side
only.
(4)
Remove screw (13) from rear lifting
bracket (12).
(5)
Remove screw (14), lockwasher (15),
bracket (16), rear lifting bracket (12) and
gasket (17) from cylinder head (18).
Discard gasket and lockwasher.
(6)
Repeat Steps (2) through (5) for left rear
lifting bracket.
b.
Follow-On Maintenance:
Remove left thermostat housing, (Para 20-7).
END OF TASK
|
