|
| |
TM 9-2320-364-34-4
27-29
(9)
Wrap masking tape on splined end of
actuating shaft (25).
(10)
Position actuating shaft (25) in bearing
cap (18).
(11)
Install retaining nut (30) and locking
pin (29) in bearing cap (18).
(12)
Remove masking tape from actuating
shaft (25).
(13)
Apply hydraulic oil to preformed packing
(28), (27) and ring (26).
(14)
Install preformed packing (28) on bearing
cap (18).
(15)
Install preformed packing (27) and ring (26)
on piston assembly (19).
(16)
Insert actuating shaft (25) and bearing cap
(18) in piston assembly (19) until bearing
cap (18) is within 3 in. (76 mm) from the
face of piston assembly (19).
(17)
Position piston assembly (19) so that ball
cavity is facing upward.
18
29
25
30
MASKING
TAPE
|
