|
| |
TM 9-2320-364-34-4
28-11
a.
Disassembly.
NOTE
Left and right side lift cylinders are disassembled the same way.
(1)
Remove holding valve (1) and preformed packing (2) from lift cylinder manifold (3). Discard preformed
packing.
NOTE
Note position of elbow prior to removal.
(2)
Remove elbow (4) and preformed packing (5) from lift cylinder manifold (3). Discard preformed
packing.
(3)
Remove four grease caps (6) and lube fittings (7) from cylinder head (8) and rod weld end (9).
NOTE
Perform Step (4) if bushings are damaged.
There are two different types of weld head configurations. If there is a shoulder machined in
the weld head between the bushings preventing the bushings from being pressed out,
bushings must be tapped out from inside of weld head. If there is not a shoulder between
bushings, both bushings can be pressed out from one side.
(4)
Remove four bushings (10) from cylinder head (8) and rod weld end (9).
2
1
5
6
4
7
10
8
9
7
6
3
3
|
